In this project I did a Christmas jumper with rgb LEDs, this can also be a creative clothing project or whatever you want, it uses rgb LEDs that are controlled by an Arduino-based microcontroller that ...

D0WD, a low-cost alternative to LilyGo T-Display, lets you mirror your desktop monitor over Wi-Fi with an ESP32 ...

Refer to the circuit diagram below for the complete wiring layout. The Raspberry Pi Pico WhatsApp messaging system reads the ...

Soldered Electronics has made ESP32-based e-paper displays for years, starting with the launch of the Inkplate 6 in 2019. The Inkplate 13SPECTRA is their ...

Orange High School senior Aanya Chepyala was recently named the Kiwanis Club of Lander Circle Senior of the Month for ...

Although generally iPads tend to keep their resale value, there are a few exceptions, such as when you find yourself burdened ...

New CodeCell C6 board adds Wi-Fi 6, Bluetooth 5, and Zigbee support plus Home Assistant compatibility, making sensor automation setup easier.

If you’ve been to a wedding or a downtown coffee shop in the last 10 years, you’ve probably seen those little lightboxes that ...

Thanks to jaromir-sukuba, and racerxdl for working on firmware to implement C2 protocol via arduino GPIO. This work largely pulls from them, as well as connorpp. C2 is a 2-pin protocol. Any arduino ...

This board boasts impressive ADC statistics with two independent 1Msps ADC's and a configurable op-amp, making it possible to have a competent scope with few or no additional components. The display ...

Arduino test code is run to see if the sensors are working properly, with built-in LED flashing when the sensor is triggered, and turning off when the sensor is released. The testing of the keys ...

You don't happen to have a microscopic phone camera yet, do you?